Skip to content

MarketPulse analysis expects October Fed and ECB pauses, with December hikes still in view

MarketPulse analyst Łukasz Zembik expects the Federal Reserve and European Central Bank to hold rates steady in October 2026, while retaining a base case of December increases. His analysis identifies French debt-market tensions as a potential constraint on ECB tightening and a risk to the euro.

A pause rather than an end to tightening

In the analysis published on 23 October 2026, Łukasz Zembik argues that persistent inflation and resilient economic activity leave room for further monetary tightening despite an expected October pause. His base case is a 25-basis-point increase by each central bank in December, rather than a confirmed policy decision. The commentary says policymakers have reasons to assess the effects of September rate increases before acting again. It also identifies geopolitical uncertainty and higher government bond yields as arguments for caution.

Inflation and growth underpin the forecast

The source reports US annual PCE inflation of 3.4% in August, with the core measure at 3.0%. It also cites euro-area headline inflation of 3.8% and core inflation of 2.5%, without specifying the reference month for those euro-area readings. Growth projections cited in the commentary are 3.5% annualised US GDP growth in the third quarter and 0.3% quarterly euro-area growth. These are forecasts, not reported growth outcomes. Zembik argues that resilient activity would allow policymakers to maintain restrictive policy, while possible energy-price spillovers remain an inflation risk.

French debt tensions complicate the ECB outlook

The analysis reports that the spread between French and German ten-year government bond yields has approached 175 basis points. It links that widening to concerns about French public finances and the government's ability to deliver fiscal consolidation. Zembik makes his December ECB hike scenario conditional on the French debt market avoiding a more serious deterioration. He also argues that worsening French fiscal conditions could weigh on the euro even if ECB guidance remains hawkish. Further tightening beyond December is less certain in his assessment. A possible normalisation of Middle Eastern oil supplies could ease energy prices, while elevated long-term yields are already tightening financing conditions. He suggests that guidance keeping December hikes in view could limit declines in short-term bond yields.

EUR/USD levels are conditional technical scenarios

Zembik describes EUR/USD as trading within a descending channel since February 2026, with its latest upward correction ending around 1.1279. His technical assessment identifies 1.1115, described as the previous week's low, as nearby support. A break below 1.1115 could open a move towards the channel's lower boundary near 1.1000, according to the analysis. Conversely, a recovery above 1.1279 could extend the correction towards 1.1340. These levels represent the author's conditional scenarios, not assured price outcomes.

OANDA

Article information

This article draws on the cited sources and relevant public material. It may include summaries, translations or supporting analysis and does not replace the full announcement, regulatory document or dataset. Check facts, definitions, statistical methods and effective conditions against the original source, particularly where a translation differs.

Companies, broker brands and legal entities must be distinguished. A licence, permission or announcement concerning one entity should not automatically be applied to related brands, other entities, products or jurisdictions. Reporting and commentary do not constitute investment advice, trading recommendations or assurances of safety, compliance or suitability.

Information is time-sensitive: announcements, register entries and data may be updated or revised. The publication and update dates on this page refer to this website’s article record and may differ from the event or original release date. Before acting, check current source material, the applicable jurisdiction and your actual contracting entity.